Quick answer
In NinjaTrader 8 Desktop, Auto Breakeven moves an ATM stop to the position’s average entry price adjusted by the Plus offset after a profit threshold is reached. Auto Trail starts at its own threshold, then moves the stop at defined intervals. Configure both through the ATM’s Stop Strategy settings.
Start in the Stop Strategy settings
In the ATM setup, choose Custom or a saved Stop Strategy template to open its configuration dialog. None leaves these stop-adjustment rules unconfigured. Save frequently used settings as a Stop Strategy template.
Check the units beside the controls. NinjaTrader does not support Currency or Price parameter types for stop strategies and uses ticks instead, identified by “(t)” beside Auto Breakeven and Auto Trail.
Auto Breakeven separates the trigger from the destination
Profit Trigger defines the favorable move needed before adjustment. Plus defines the stop’s offset from the ATM position’s average entry. For a long position, add that offset to the entry price; for a short position, subtract it.
Consider a hypothetical long entry at 100.00 in an instrument with a 0.25 tick size. A trigger of 8 ticks activates at 102.00. With Plus set to 1 tick, the new stop price is 100.25. The trigger and the stop destination are different prices. These numbers illustrate the calculation, not a recommended setup.
NinjaTrader documents a Log-tab event when Auto Breakeven adjusts the stop. The setting changes an order price; it does not establish the eventual execution price.
Auto Trail has three controls for each step
Profit Trigger starts a trail step after the specified favorable move. Stop Loss sets the trailing distance behind the trigger or subsequent adjustment level. Frequency sets the further price movement needed for another adjustment.
For a separate hypothetical long example, use entry 100.00, tick size 0.25, trigger 4, distance 6 and frequency 2. At 101.00, the first adjustment places the stop at 99.50. At 101.50, the next adjustment moves it to 100.00. A trail can therefore activate while its stop is still below entry.
NinjaTrader supports up to three steps with different settings. A later step can tighten the distance or change the adjustment interval. Frequency is measured in price movement, not seconds.
When the active stop does not move
Inspect the working order’s controls. In the SuperDOM, right-click the stop’s buy or sell cell, select the relevant working order and inspect its strategy submenu. Auto Breakeven and Auto Trail can each be enabled or disabled there. Their Properties commands allow parameter changes while the corresponding feature is disabled.
Compare the actual price move with the configured threshold and, for subsequent trail moves, the frequency. Review the working stop and Log tab rather than assuming that selecting a template proves an adjustment occurred.
Official sources
Ninja Watchdog
Monitor the platform behind your strategies
Ninja Watchdog monitors NinjaTrader availability and supports platform recovery. It does not directly place, change or cancel orders. Email alerts are available today; SMS and WhatsApp are coming soon.
